During construction, sintered porous bricks are often applied to the coal seam, and then reduce cracks and increase the beauty of the tile. Together, it can travel its quality and then extend its service life. Therefore, in the construction joints, some details are worthwhile to ensure the construction base. It is necessary to be lubricated, robust and dust-free.
The width of the joints of the sintered porous bricks can be positioned with plastic penetration, otherwise it will affect the beauty. The mouth of the discharge port should be smaller. After each connection, the discharge port will be leaked because a small amount of material overflows. The caulking discharge needs to be more simple and careful. To a length of about 1 meter, you can't scrape it smoothly for a period of time and then scrape the joints of the joints on the outer surface of the joint sealant. If it is missing, you can clean it.
The width of the discharge opening is based on the width of the slit to ensure that the sintered porous brick fabric completely covers the bottom layer. It is assumed that the sintered porous brick fabric is completely washed away with clean water immediately if necessary, and seek medical treatment if necessary. After the initial curing, the joint is sintered with a slightly moist sponge. The void filler on the surface of the porous brick is clean. It is assumed that uncleaning will affect the beauty.
The construction of smaller bricks at the interface should be drawn at the top of the vertical seam, and then use the principle of horizontal seam. At the intersected intersection, here, pay attention to scraping past the conventional joint sealant, so that the unsightly joint enters the cross stitch.
After construction on the ground, after 24 hours of walking, 72 hours of dust-free contact with the beautiful cracks at the joints.
After the above introduction, we can know that the beauty of the sintered porous brick seam is an indispensable beauty agent, so pay attention when using it. When you don't need to pay attention to the maintenance of the tile, try to be in a moderate temperature, ventilated, monotonous environment as much as possible. Power that can travel construction joints.