What to do if the cement pipe splice is leaking
What to do if there is leakage at the joint of cement pipe, cement pipe is a kind of underground drainage pipe, we all know that the cement pipe is a piece by piece, we will splice multiple cement pipes when installing, this is if the splicing work is not done , There may be water leakage in the cement pipe. What should we do in response to this leakage? Let us learn:
According to the standard construction, mouth cleaning, chiseling, grouting, caulking, jointing, compaction and polishing. The foundation should also be done well, after the interface should pay attention to maintenance, and later care is also very important.
Use asphalt bast to plug the seam, apply a layer of asphalt on its surface, and then wrap it with linoleum within a certain width of the seam opening, and then apply a layer of asphalt, so-called "two oils and two materials". Culverts are basically treated this way.
It depends on whether you are a socket pipe or a flat pipe. To ensure that there is no water leakage, the same foundation must be prepared. The concrete cushion layer can be poured first, and then the tube can be installed, and the mouth of the nozzle can be leveled. The socket pipe should be properly mortared at the lower mouth of the pipe to ensure that the width around the mouth is consistent. The crevice wipes the seam to block the pipe tightly.
The pipe is sealed with a seal at the seam of the pipe, which is a standard operation. Only if the construction is strictly performed according to the construction operation standard can the leakage be reduced. In order to be 100% watertight, it is necessary to choose a flexible interface, that is, a rubber strip rubber ring interface for the cement pipe. The rubber ring is acquired from the supplier when the cement pipe can be purchased.