Although we know that cement pipes have many benefits when we understand them, this does not mean that there is no problem when using cement pipes. If we don't say anything else, when we look at the installation of cement pipes, there will be many problems. We all know that cement pipes are segment by segment. During the installation, we will splice multiple cement pipes. This is because if the splicing work is not done well, the cement pipe may leak water. Today, the editor of Wanxin will tell you about the solution to the leakage of cement pipes.
According to the standard construction, mouth cleaning, chiseling, grouting, caulking, jointing, compaction and polishing. The foundation should also be done well, care should be taken after the interface, and later care is also critical.
Use asphalt bast to plug the seam, apply a layer of asphalt on its surface, and then wrap it with linoleum within a certain width of the seam opening, and then apply a layer of asphalt. Culverts are basically treated this way.
Depends on whether you are a mouth pipe or flat mouth pipe, to ensure that there is no water leakage, the same foundation must be done well. The concrete cushion layer can be poured first, and then the tube can be installed, and the mouth of the nozzle is flat. The socket pipe should be properly mortared at the lower mouth of the pipe to ensure the width and narrowness of the pipe mouth. Plug seams to block the seams tightly. The pipe is sealed with a seal at the seam of the pipe. It is a standard operation. Only in strict accordance with the construction operation standards can the leakage be reduced. To be 100% watertight, a flexible interface must be selected, that is, a rubber strip and aprons interface used with cement pipes. The rubber ring is acquired from the supplier when the cement pipe can be purchased.