北京pk10全部赛车记录

page contents ');}) ();

Analysis of daily inspection and maintenance of cement control pipe machine

share to:
更新时间:2019年10月12日14:33:37 打印此页 关闭 Clicks: 168 Updated: October 12, 2019 14:33:37 Print this page Close
With the rapid development of urban construction today, the scope of application of cement drainage pipes is becoming wider and wider. It is mainly used in the construction of urban sewers in urban construction. In our daily life, many local cities cannot rely on the use of cement drainage pipes. . During the production of cement drainage pipes, the wear of the pipe making machine is very serious. In order to reduce the wear of the pipe making machine and ensure the quality of the cement drainage pipe, the editor of the cement pipe factory below will tell you about the cement drainage control. Maintenance and protection of pipe machines.

The maintenance and protection of cement drainage pipes are mainly done from 5 aspects:

1. Always check the smooth points, fasteners and other parts.

2. Air filters, coolers, fuel tanks and oil filters should be cleaned frequently to keep the oil circuit open.

3. The pipe making system generally uses 20 #, 30 # anti-wear hydraulic oil.

4. The suitable oil temperature for hydraulic oil is 30-55 degrees. When the oil temperature is lower than 15 degrees or higher than 60 degrees, it is forbidden to turn on the machine. To adjust the oil temperature, a heater or a cooler can be used.

5. The hydraulic oil is usually replaced once every 6 months, and the fuel tank and oil pipe should be thoroughly cleaned when replacing. The deterioration and dirty of the cement pipe making machine will increase the noise of the system, the life of the oil pump, the oil cylinder, the reversing valve will be reduced, and even the entire system will be paralyzed. You must pay attention from time to time.
下一条: 如何保证水泥管施工的时候漏水 Previous : Analysis of various characteristics of cement pipe joints Next : How to ensure water leakage during cement pipe construction